1. A technician needs to connect a fiber cable to a distribution panel that has a round barrel connection. Which of the following would be required?

A) A. SC
B) B. LC
C) C. BNC
D) D. ST



2. A technician is tasked with finding and labeling where a network connection terminates in a patch panel. Which of the following tools would be BEST for the technician to use?

A) A. Ethernet cable tester
B) B. Tone generator and probe
C) C. RJ-45 loopback plug
D) D. Patch panel punchdown tool



3. A technician is tasked with replacing all the APs in an office building for greater speeds. The current location of APs allowed for total coverage of WiFi throughout the office. Which of the following 802.11 standards should be used?

A) A. a
B) B. ac
C) C. b
D) D. g
E) E. n


4. A customer has a printer that needs to be installed and wants to be able to print on both sides of the paper. Which of the following needs to be considered?

A) A. Orientation
B) B. Duplexing
C) C. Collating
D) D. Scaling



5. A technician is tasked with upgrading the hard drives of a high-end workstation to SSD. The drives must be configured in a RAID array, but the RAID card does not support SSD. Which of the following would the technician verify in order to use the new drives?

A) A. Controller firmware
B) B. Power requirements
C) C. File system type
D) D. System BIOS