1. Which virtual router states are defined in the GLBP protocol? (Choose two.)(Select 2answers)

A) Backup gateway
B) Primary gateway
C) Active virtual gateway
D) Active virtual forwarder



2. You have configured three routers in HSRP group 10 to provide gateway redundancy for VLAN 56. Your intention was for Router 1 to be the active router in the group and for Router 3 to be the standby router. Furthermore, in the event that Router 1 became unavailable, resulting in Router 3 becoming active, you intended for Router 1 to resume its role as active when it came back online. However, you discover that in practice, Router 1 does NOT resume the active role when it comes back online. What command should be executed on Router 1?

A) router1(config)# standby 56 preempt
B) router1(config)# standby 10 preempt
C) router1(config)# interface VLAN 56router1(config-if)# standby 10 preempt
D) router1(config)# interface VLAN 10router1(config-if)# standby 56 preempt



3. What IOS VLAN commands would create a new VLAN and assign it to a port? (Choose two.)(Select 2answers)

A) switch(config)# vlan 10
B) switch(config-if)# switchport access vlan 10
C) switch(config-if)# switchport vlan 10 enable
D) switch(config)# vlan database 10



4. How long does it take for a port to transition from the STP blocking state to the forwarding state by default?

A) 2 seconds
B) 10 seconds
C) 25 seconds
D) 50 seconds



5. You need to create an implementation plan for providing Layer 3 redundancy in your switched network. You included Hot Standby Routing Protocol (HSRP) as the protocol to avoid first-hop router failure. However, your supervisor suggests including Virtual Router Redundancy Protocol (VRRP) instead of HSRP in the implementation plan. Which of the following statements is TRUE about the reasons for the suggested change in the implementation plan? (Choose two.)(Select 2answers)

A) HSRP-enabled routers automatically preempt the active router and VRRP-enabled routers need to be configured manually to preempt the activerouter
B) HSRP works on both Cisco and non-Cisco routers and VRRP works only Cisco routers.
C) HSRP works only on Cisco routers and VRRP works on both Cisco and non- Cisco routers
D) HSRP-enabled routers need to be configured manually to preempt the active router and VRRP-enabled routers preempt it automatically.